Liquid tank guide

Package information

Liquid tank

Width dimension: 47 cm

Depth dimension: 57 cm

Height dimension: 58 cm

Gross weight: 21 kg

Net weight: 13 kg

Unboxing

Check the box warning labels for damages and if you see any warning or damage, please get in touch with the courier company. Please check if the machine has been damaged after cutting the fixing straps. In case of immediate objections and feedback to your dealer or Yena Makina A.Ş, it will be possible to get results in problem-solving.

Assembly

Make sure to fix the hose inside the "Liquid" quick fitting.

Outer diameter: 8mm

Make sure the hose does not bend.

Make sure to push the hoses to the end on the 90 degree fittings and tighten the clamps with the screwdriver tightly.

If the placed table surface is longer at the end it might bend the free fall discharge hoses bended. Make sure they are bended and liquid is discharge flow is okay. If not your machine will be flooded.

Liquid mixture

Cutting fluid

€20.00

Metal only use: %5 refractometer reading

Ceramics only use: %3 refractometer reading

Metal and Ceramics use: %4 refractometer reading

Cuting oil

€66.66

You must use "oil liquid tank" instead of "regular liquid tank" if you prefer cutting oil.

You can understand if your tank is oil or regular by checking kW option on the tag. Oil tank is 0.25kW, regular tank is 0.09kW.

Pure oil does not need a refractometer reading, just fill your tank and you will be ready for milling.

Recommended water used should be deionized water, distilled water or purified water.

Add your water and then gently add your cutting fluid. ( 18lt water to 1lt cutting oil produces approximately 4-5% refractometer reading. )

Make sure the mixture blended by stirring with a long stick-like object.

Then you need to check the mixture ratio with a refractometer.

You may need to add more water or cutting liquid according to your reading on the refractometer.

Refractometer

Collect a little mixture into your pipette.

Drop a few droplets onto the reading surface of your refractometer.

Close the lid.

Put the lens to your eye and point the refractometer to a light source for better reading.

If your measurement is correct you are done with the process.

If your measurement is higher than you want you need to add more water to the mixture. Then measure again.

If your measurement is lower than you want you need to add more cutting fluid to the mixture. Then measure again.

You need to clean your refractometers surface with a washcloth or napkin between the readings or when you are done and storing your refractormeter.

Water evaporates, make sure to check your mixture ratio monthly.