6P Premill holder guide - Yenadent

YP-6 Premill holder

YP-6 Premill holder

YM000000022

Premill holder, compatible with D15, D43N, D6, DC40.

€800.00

Assembly

Use 4 screw that is suitable for your machine.

Make sure to screw the holder tightly.

Before inserting the premill, make sure the corresponding screw is loose.

After tightening, check if the premill is fully stable.

Calibration

You need these products to do premill calibration.

Calibration premill

€2.00

YT203

€32.00

Navigate to this folder in your CAM computer.

This PC > Documents > YenaDent Cam 6 > Parameters > Select your machine > Calibration > Premill

Each premill position requires separate calibration.

Run a calibration program in CNC software for the position you want to calibrate.

After opening the block you want to use, click the preparation tab in the menu. Then choose the number you want to calibrate and right-click and select calibration.

Measure the milled calibration premill and enter your values into corresponding boxes.

You can find the measurement guide below.

A1

A2

B1

B2

C

D

Calibration is done!

Product added to wishlist

Product added to compare.